DESIGNING TO YOUR NEEDS - Display and MCU are mounted on the same board (mainboard) to avoid using inter-board pin-headers. Analog channel is placed on a separate board that contains most user install parts, so the analog and digital circuits can be better separated.
ROTARY ENCODER - It has been added the rotary encoder, makes parameter adjustment quicker and easier.
ASSEMBLED FINISHED - AUKUYEE Q15001 oscilloscope is an Assembled finished Machine. NOT DIY PART, it can be used directly to avoid assembling welding process problems and greatly saves the assembly time.
WHAT YOU GET - You will get an assembled oscilloscope, BNC-clip cable and a power pupply. Detailed Operation instructions troubleshooting guide and schematic are also provided.
NOTE：Please Calibrate the oscope Before Use! Please Refer to the Video(Oscilloscope Calibration-Latest Version) on the product page.
1. Extended sensitivity
Sensitivity has been expanded in both width and height, which is wider than another similar product. It reaches 5 mV / div - 20 V / div, while another similar product is only 10 mV / div - 5 V / div.
2. Simply measure
With the Auto / Normal / Single Trigger mode, you can easily capture the current waveform.
The encoder has been added, making parameterization quicker and easier.
4. Maintenance function
You can keep the waveform at any time.
5. Waveform memory function
You won't lose the waveform after turning off the wave.
6. Professional assembly
The display and the MCU are mounted on the same board (mainboard) to avoid the use of connecting heads between the boards. The analog channel is on a separate board that contains most of the parts installed by the user so that the analog and digital circuits can be better separated.
This updated digital oscilloscope can be hand-held and is more practical than other products.
Basic Button Functions
[V/DIV]: Select sensitivity or vertical position,The selected parameter indicator will be highlighted.
[SEC/DIV]: Select timebase or horizontal position. The selected parameter indicator will be highlighted.
[TRIGGER]: Select trigger mode, trigger level, and trigger edge. The selected parameter indicator will be highlighted.
[OK]: Enter HOLD state (freeze waveform). Pros it again will de-freeze.
[ADJ]: Adjust the parameter selected (highlighted). Short press toggles Fast Adjustment mode.
Couple switch: Set couple to DC, AC, or GND. When GND is selected the scope input is isolated from input signal and connected to ground (0V input).
Before you start
Please Calibrate the oscope Before Use.Please Refer to the Video(Oscilloscope Calibration-Latest Version) on the product page.
Please check kit contents and part quantities/values by the photo at right.
Resistor values are easy to misread. It is strongly suggested to check their values by ohm-meter before soldering them to the board.
Make sure you understand the polarities and orientations of all parts.
Max realtime sample rate: 1 MSa/s
Sensitivity range: 5mV/div - 20V/div
Input Impedance: 1M ohm/20pF
Maximum Input voltage: 50Vpk
Record length:1024 bits
Timebase range: 500s/Div-10us/Div
Display: 2.4 inch color TFT LCD with 320 x 240 resolution
Power Adapter: 9V DC ( 8-10V )
Dimension: 115mm X 75mm X 22mm
Weight: 100 grams (without cable and power adapter)
1* BNC-clip cable
1* Users Manual